finished the forward and reverse manifolds, next will be the reversing valve.
Steam Simplicator
Monday, October 2, 2017
Saturday, September 23, 2017
back together
Added a valve to the new manifold and got it spinning again. The weather is getting frosty in the mornings.
Monday, September 18, 2017
Saturday, September 2, 2017
Monday, August 7, 2017
Reasons
Due to reasons
I will likely not have much progress on this project until the middle of September.
I am getting close to the end of the summer semester at school and need to focus on that for a little while.
photos of the existing Steam Simplicator project can be found at
https://goo.gl/photos/xRq65k2VYWNcneeH7
I will likely not have much progress on this project until the middle of September.
I am getting close to the end of the summer semester at school and need to focus on that for a little while.
photos of the existing Steam Simplicator project can be found at
https://goo.gl/photos/xRq65k2VYWNcneeH7
Tuesday, July 18, 2017
Realigning the Warp Core
Had to re-engineer (due to reasons) one of the engine's trunnions (pivot plate )
hope this one works better.
hope this one works better.
what I need for Christmas/Yule
If anyone would like to help out,I need 4 of these to make the "steam generator" (Boiler)
Copper Tubing from Ebay
http://www.ebay.com/itm/Mueller-Industries-100-ft-Soft-Coil-ACR-Copper-Tubing-3-8-Outside-Dia-/132171571321?hash=item1ec60a2079:g:lQcAAOSwRUhZAJ6B
Copper Tubing from Ebay
http://www.ebay.com/itm/Mueller-Industries-100-ft-Soft-Coil-ACR-Copper-Tubing-3-8-Outside-Dia-/132171571321?hash=item1ec60a2079:g:lQcAAOSwRUhZAJ6B
Subscribe to:
Posts (Atom)
forward and reverse manifolds done
finished the forward and reverse manifolds, next will be the reversing valve.
-
This is my Penberthy Automatic Boiler feedwater injector. It is based on 1800's technology to use a boiler's own steam pressur...
-
i found a rare treasure on ebay. it is a split #40 chain sprocket with a 3/4 inch bore. With this I can directly and easily install the spro...
-
Started making the forward manifold. Will be connecting them with flared fittings and copper tube.