hope this one works better.
Tuesday, July 18, 2017
Realigning the Warp Core
Had to re-engineer (due to reasons) one of the engine's trunnions (pivot plate )
hope this one works better.
hope this one works better.
what I need for Christmas/Yule
If anyone would like to help out,I need 4 of these to make the "steam generator" (Boiler)
Copper Tubing from Ebay
http://www.ebay.com/itm/Mueller-Industries-100-ft-Soft-Coil-ACR-Copper-Tubing-3-8-Outside-Dia-/132171571321?hash=item1ec60a2079:g:lQcAAOSwRUhZAJ6B
Copper Tubing from Ebay
http://www.ebay.com/itm/Mueller-Industries-100-ft-Soft-Coil-ACR-Copper-Tubing-3-8-Outside-Dia-/132171571321?hash=item1ec60a2079:g:lQcAAOSwRUhZAJ6B
Monday, July 17, 2017
Friday, July 14, 2017
a wee bit of Split Happiness
i found a rare treasure on ebay. it is a split #40 chain sprocket with a 3/4 inch bore. With this I can directly and easily install the sprocket without needing to remove the entire RUSTED axle.
Just a little bit of happiness today.
The down side was that the postal service lost it for nearly a week.
Just a little bit of happiness today.
The down side was that the postal service lost it for nearly a week.
Subscribe to:
Posts (Atom)
forward and reverse manifolds done
finished the forward and reverse manifolds, next will be the reversing valve.
-
This is my Penberthy Automatic Boiler feedwater injector. It is based on 1800's technology to use a boiler's own steam pressur... -
i found a rare treasure on ebay. it is a split #40 chain sprocket with a 3/4 inch bore. With this I can directly and easily install the spro... -
Started making the forward manifold. Will be connecting them with flared fittings and copper tube.